instructions for
mobile project station with 5 drawers &
perforated back panel in red and black
model no:
ap335m, ap335mb
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
1. safety
9
only use on firm, level, unobstructed surfaces which are capable of supporting the trolley.
8
do not
overload.
9
Apply the brakes when stationary.
8
do not
stand/ride on the trolley, climb on open draws or allow others to do so.
9
replace or repair damaged parts. use only recommended parts. unauthorised parts may be dangerous and will invalidate the warranty.
9
two persons maybe required to assemble the unit.
warninG!
the warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
and situations that may occur. it must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
2. introduction
f
ive drawer mobile project station is perfect for use in any garage or workshop environment. All drawers are fitted with aluminium drawer
pulls, non-slip liners and 45mm secure latch ball bearing slides. Perforated back panel is ideal for hanging frequently used tools so they are at
hand when needed (compatible with our range of tts model no’s). the back panel can also be folded down when not in use for easy storage.
Cabinets also feature four storage bins at the back suitable for keeping small parts and fixings within easy reach and a 6mm protective EVA foam
work surface. Fitted with a steel chrome plated handle and four Ø125mm HDR castor wheels, two locking and two fixed, which allow for smooth
and quiet manoeuvrability around the work area. supplied with two keys.
3. specification
model no: .................................................AP335m/AP335mB
o
verall Size: (W x D x H)
........................
760 x 480 x 890mm
overall size with Pegboard ...................
760 x 480 x 1385mm
m
edium Drawer Size (x3)
..........................
585 x 380 x 70mm
large drawer size .................................
585 x 380 x 155mm
large drawer size (bottom) ....................
585 x 380 x 175mm
4. assembly
4.1.
unpack all parts and check against parts diagram below.
4.2.
taking care turn the unit on to its top surface and place on a surface that will not damage the unit.
4.3.
using assembly diagram 1 attach casters (ensure the swivel / brake castor is located at the same end as the handle).
Original Language Version
© Jack sealey limited
refer to
instructions
AP335m, AP335mB issue 1 22/12/17
