INSTRUCTIONS FOR:
2 DOOR FLOOR CABINET
MODEL No:
AP02DFC
1. SAFETY INSTRUCTIONS
2. INTRODUCTION
1.1
GENERAL SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice
regulations are adhered to when using this cabinet.
WARNING!
Use caution when handling and assembling the metal components. The metal may
have sharp edges or corners, the use of protective gloves is recommended.
Locate cabinet in a suitable working area and secure to a wall with suitable fasteners.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
Keep the cabinet clean and tidy in accordance with good workshop practice.
Keep children and unauthorised persons away from the working area.
DO NOT
climb, step or stand on the cabinet shelves.
DO NOT
use the cabinet
for any purpose other than that for which it is designed.
DO NOT
exceed the maximum weight allowance for each shelf, 45kg (100lbs).
DO NOT
use in damp work areas.
WARNING!
The warnings, cautions and instructions referred to in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood that common
sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE
KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
AP02DFC
Issue No: 1 - 06/08/08
Metal storage cabinet with silver-grey doors and graphite grey carcass, features three shelves,
which can be easily adjusted and lock with two keys.
Overall Size (W x D x H):
762 x 381 x 1666mm
Fig.1
3. ASSEMBLY
3.1
CONTENTS INSPECTION
Unpack all the parts and layout on the packing material. Visually inspect all panels to
check for transportation damage, sometimes the corners of the panels become slightly
bent, if this happen gently straighten using your hand. Some of the connecting tabs may
also have closed up during transportation, prise them open with a small flat bladed
screwdriver.
NOTE:
It is recommended to open all the tabs up slightly to ease the assembly of the cabinet, the
tabs can then be tapped back down with a rubber mallet, see Fig.2.
