mINI LASER LEVEL UNIT
MODEL NO:
AK9999.V3
Thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAfETy
1.1.
GENERAL SAfETy.
Read instructions carefully before using the laser level.
8
DO NOT
use this device in direct sunlight.
8
DO NOT
allow the level to get wet.
8
DO NOT
allow unqualified persons or children to operate this device.
1.2.
LASER SAfETy.
The AK9999.V3 utilises a Class II laser that emits a low level of visible radiation (i.e. a wavelength of 650
nanometres) which is safe for the skin but not inherently safe for the eyes. The Class II emission limit is set at the maximum level for
which eye protection is normally afforded by natural aversion responses to bright light. Accidental eye exposure is therefore normally
safe, although the natural aversion response can be overridden by deliberately staring into the beam, and can also be influenced by
the use of alcohol or drugs.
8
DO NOT
direct the laser beam at any person’s (or animal’s) eyes as eye damage could result.
8
DO NOT
operate the laser level when you are tired or under the influence of alcohol, drugs or intoxicating medication. Be aware that
reflections of the laser beam from mirrors or other shiny surfaces can be as hazardous as direct eye exposure.
2. INTRODUcTION
Approved for use with Model no. HBS97 MOT approved Headlamp Beam Setter. Mini tripod can be placed on bonnet or any surface on the test
area. Laser dot indicates a beam setter is in or out of calibration. Also suitable for other levelling applications and features a magnet on the base
for attaching to ferrous surfaces.
3. SpEcIfIcATION
Model no ................................................................ AK999.V3
Laser power ...............................................................
≤ 1mW
W
avelength ....................................................................650Nm
Accuracy ........................................................................1mm/m
Batteries .........................................................2 x AAA supplied
W
eight ......................................................................... 0.27kg
4. bATTERy INSTALLATION
4.1.
Slide the cover up and hinge down as in fig.1 to open.
4.2.
Insert the batteries as in fig.2 observe correct polarity.
4.3.
Close compartment door, reverse of 4.1.
.
Refer to
instruction
manual
Warning!
Laser beam
AK9999.V3| Issue:2 H,2,F) 17/08/18
Original Language Version
© Jack Sealey Limited
fig.1
fig.2
