1.1 Safety Instructions
WARNING!
Ensure Health & Safety, local authority and
general workshop practice regulations are adhered to
when using this tool.
DO NOT
use the suction cup if any parts are damaged or
missing as this may cause failure and/or personal injury.
Before each use, check condition of suction cup. Examine
rubber pads for excessive glaze, cuts or roughness. If any
component is worn or damaged replace immediately.
DO NOT
clean the suction cup with solvents or other
harsh chemicals.
Use genuine parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
Use in a suitable work area. Keep area free from
unrelated materials and ensure that there is adequate
lighting.
WARNING!
Always wear approved eye, face and hand
protection when using the suction cup.
Remove ill fitting clothing. Remove ties, watches, rings,
other loose jewellery and contain and/or tie back long hair.
Maintain correct balance and footing.
DO NOT
over reach,
ensure the floor is not slippery, wear non-slip footwear.
Keep children and unauthorised persons away from the
working area.
Ensure workpiece is secure before attaching and using
the suction cup.
WARNING!
Ensure that the surface to which the suction
cup is to be attached is non-pourous, clean, dry and free
from oil and grease.
DO NOT
exceed the maximum pull capacity of the suction
cup.
DO NOT
use the suction cup for any purpose other than
that for which it is designed.
DO NOT
use the suction cup when you are tired or under
the influence of alcohol, drugs or intoxicating medication.
When not in use, store in a safe, dry, childproof location.
DO NOT
use any sharp object to loosen the suction
cup as it may damage the rubber and prevent the tool
from creating suction.
DO NOT
attempt to attach the suction cup to a person as
severe bruising and/or damage to internal organs can
occur.
DO NOT
allow anything to interfere with the free
movement of the plunger whilst the suction cup is
attached to a surface.
Keep fingers clear of suction release tag during use.
DO NOT
allow anything else to touch the release tab
whilst in the process of lifting e.g. other lifting gear or
adjacent fixtures and fittings.
InStRUctIonS foR:
VACUUM SUCTION CUPS - 40kg
ModEl no's:
Ak98941 & Ak98942
thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/
OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE kEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. INTRODUCTION & SPECIFICATION
Ak98942
is a profiled rubber suction cup suitable for
attachment to
CURVED SURFACES
such as windscreens.
Red line indicator warns of any vacuum loss. can also be used
on smooth, non-porous flat surfaces such as glass, sheet metal
and tiles.
Original Language Version
AK98941, AK98942 Issue: 1 - 23/07/12
© Jack Sealey limited 2012
Model No:
Ak98941
Ak98942
Size:
Ø178mm
Ø178mm
Maximum Lift Capacity:
40kg (horizontal)
40kg (horizontal)
Ak98941
is a rubber suction device with a red line indicator
which warns of any vacuum loss. Easy attachment on smooth,
non-porous
FLAT SURFACES
such as glass, sheet metal and
tiles.
