MEDIUM-ARM QUICK RELEASE THREADED
NUT RIVETER
MODEL NO:
AK3988
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using this equipment.
9
Familiarise yourself with the application and limitations of the riveter, as well as the potential hazards.
9
Maintain the riveter in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the riveter clean for best and safest performance.
WARNING!
Always wear approved eye or face protection when operating the riveter.
9
Keep children and unauthorised persons away from the working area.
9
Check moving parts alignment on a regular basis.
8
DO NOT
hold the workpiece by hand. Secure unstable workpiece with a clamp, vice or other adequate holding device.
9
Ensure the workpiece is correctly secured before operating the riveter.
8
DO NOT
use the riveter for any purpose other than that for which it is designed.
8
DO NOT
operate the riveter if any parts are damaged or missing, as this may cause failure and/or personal injury.
9
When not in use return to the case and store in a safe, dry, childproof area.
2. INTRODUCTION
Suitable for rivet nuts in aluminium, steel and stainless steel.
M
edium arms provide effortless functionality and pull through quick release mechanism.
3. SPECIFICATION
Model no. .................................................................. AK3988
Mandrels:
.................................................................M3 x 0.5, M4 x 0.7,
....................................................................M5 x 0.8, M6 x 1,
.............................................................M8 x 1.25, M10 x 1.5,
........................................................................M12 x 1.75mm
Length ........................................................................ 345mm
Rivet types ... aluminium, steel, stainless steel (not structural)
4. OPERATION
Numbers refer to Parts Diagram. Tool shown for reference only.
4.1.
CHANGE MANDREL
Step 2: Slide back sliding rod
(14) and use supplied spanner
to hold tie rod (15) in position.
Step 1: Remove guide cap (18) and
jaw sleeve (16)
AK3988 Issue 1 26/05/20
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
