IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
Refer to instruction
manual
Wear eye
protection
Wear
protective gloves
Wear
protective clothing
1. SAFETY
AK36D.V2, AK80D.V2 Issue:1 - 12/10/17
Original Language Version
© Jack Sealey Limited
INSTRUCTIONS FOR:
MOBILE OIL DRAINER 36ltr, 80ltr MANUAL
DISCHARGE
MODEL NO:
AK36D.V2, AK80D.V2
1.1 GENERAL SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop
practice regulations are adhered to when using this equipment.
Familiarise yourself with the application, limitations and hazards of the oil
drainer.
Maintain the
drainer in good condition (use an authorised service agent).
Replace or repair damaged parts.
Use genuine parts only. Unauthorised
parts may be dangerous and will invalidate the warranty.
Keep the work area clean, uncluttered and ensure there is adequate
lighting.
Keep the drainer clean for best and safest performance.
Maintain correct balance and footing. Ensure the floor is not slippery and
wear non-slip shoes.
Keep children and unauthorised persons away from the work area.
DO NOT
use the drainer for any purpose other than that for which it is
designed.
DO NOT
operate the drainer if any parts are damaged or missing as this
may cause failure and/or personal injury.
DO NOT
stand on the drainer.
DO NOT
allow untrained persons to operate the drainer.
DO NOT
operate the drainer when you are tired or under the influence of
alcohol, drugs or intoxicating medication.
When not in use, store in a safe, dry, childproof area.
Dispose of waste oil in accordance with local authority regulations.
Polyethylene reservoir, 36/80ltr capacity, mounted on four castors for mobility. Drain pan, with filter, on height adjustable down tube. Hand grips for
manual emptying (AK36D.V2): rotary pump or gravity drain tap for emptying (AK80D.V2)
2. INTRODUCTION
3. SPECIFICATION
Model No:
. . . . . . . . . . . . . . . . . .
AK36D.V2
. . . . . . . . . . . . . . .
AK80D.V2
Capacity: . . . . . . . . . . . . . . . . . . . 36ltr. . . . . . . . . . . . . . . . . . . . . . . . . .80ltr
Minimum Height to Pan: . . . . . . . 760mm . . . . . . . . . . . . . . . . . . . . 760mm
Maximum Height to Pan: . . . . . . . 1600mm . . . . . . . . . . . . . . . . . . 1600mm
4. ASSEMBLY
4.1.
Insert the lower tube through lower tube clamp and secure by tightening the clamp.
4.2.
Place the tool tray over the lower tube.
4.3.
Insert the upper tube into the lower tube.
4.4
. Slide the upper tube retaining clip down the upper tube (press the two ends together to release the grip) until the clip rests on the lower
tube
at the required level.
4.5.
Place the drain pan on top of the upper tube.
5. OPERATION
5.1.
Place mobile oil drainer under the equipment to be drained. Raise the drain pan beneath the equipment’s drain valve or vent.
5.2.
When draining is complete, lower the drain pan before removing the drainer.
5.3.
EMPTYING OIL DRAINER (AK36D.V2)
5.3.1. Disconnect the drain pan and release the tubes from the reservoir. Remove the cap from the drain port.
5.3.2. Using the hand grips, tip the reservoir to dispose of the waste oil into a suitable container.
5.4. EMPTYING OIL DRAINER (AK80D.V2) by gravity.
5.4.1. Connect a drain hose to the drain tap.
5.4.2. Empty the reservoir by opening the drain tap and draining by gravity to a lower level tank.
fig.1
