Seagull
#MAP2
- Manual
General information
With Seagull #MAP2 you can easily trigger your camera – either with your R/C transmitter from the ground, or let your Flight
Controller do the job.
Seagull #MAP2 is designed to connect your UAV mounted camera to an R/C receiver or Flight Controller and be able to
trigger the camera either from a dedicated switch on your R/C transmitter - or automated by your Flight Controller for doing
for example image mapping, agriculture analysis, 3D modelling and more.
Seagull #MAP2 features 6 modes:
AF-T
( Autofocus-Trigger, 1 sec pre-AF then trigger )
IS-T
( Instant-Trigger, instant trigger as soon as camera locks focus )
Camera On/Off
( Turn camera power on/off –
only with Sony "Multi" cameras
! )
Timelapse
( Shutter release with variable time interval )
Keep-alive
( QX1 camera keep-alive function, prevents camera from shutting off )
Please read this manual thoroughly before connecting and configuring Seagull #MAP2 !
Configuring your Transmitter
Setting up Seagull #MAP2 could not be easier!
Simply select the channel that the device is plugged into and trim the LOW/HIGH values for that channel, until desired modes
are met – refer to the table below:
Channel
State / Mode
Value
Value range
1, 2
Neutral
1500
μ
S
1400 <> 1600
μ
S
1
AF-T
1300
μ
S
1200 <> 1400
μ
S
1
IS-T
1700
μ
S
1600 <> 1800
μ
S
1
Camera On/Off *
1100 / 1900
μ
S
1000 <> 1200
μ
S / 1800 <> 2000
μ
S
2
Timelapse
- 1 Second
- 2 Second
- 3 Seconds
- 4 Seconds
- 5 Seconds
- 10 Seconds
- 15 Seconds
- 20 Seconds
1375
μS
1325
μS
1275
μS
1225
μS
1175
μS
1125
μS
1075
μS
1025
μS
1351 <> 1399
μS
1301 <> 1350
μS
1251 <> 1300
μS
1201 <> 1250
μS
1151 <> 1200
μS
1101 <> 1150
μS
1051 <> 1100
μS
1000 <> 1050
μS
2
Keep-alive
1700
μ
S
1600 <> 1800
μ
S
2
Camera On/Off *
1900
μ
S
1800 <> 2000
μ
S
1 & 2
No signal **
n/a
0 <> 1000
μ
S / 2000 <>
∞
μ
S
Example with Seagull #MAP2 configured to CH7 on a Taranis X9D transmitter:
* Only with Sony "Multi" cameras !
On/Off function is placed at either extremes of the signal
range to be able to utilize a 3-position switch and still reach
both trigger functions.
** Signal out of scope or no input signal !
No signal state will occur when signal is out of the
standard R/C PWM signal range or if no signal is received.
