Seagate Lyve Mobile Array, User Manual

Page: 86 / 117

3. Enter the following command:
sudo systemctl restart multipathd
Set up IP addresses for Lyve Mobile Rackmount
Receiver iSCSI ports
Install Lyve Client So ware app
Install the Lyve Client app on a Windows or Mac computer connected to the management network. Links to
the installer can be found on Lyve Management Portal:
1. Log in to lyve.seagate.com .
2. On the Home page, click Downloads.
3. At the prompt, click Download for either Windows or macOS .
4. Go to the folder where you receive downloads and open the installer.
5. Follow the onscreen instructions to complete the setup and open Lyve Client.
You can also download Lyve Client installers from the support page at www.seagate.com/support/lyve-
client .
Unlock the device
Open the Lyve Client app.
Lyve Client will automatically unlock the device if the management computer was connected to Lyve Mobile
Array in the past and is still authorized for security. If the management computer has never unlocked the
device, you will need to enter your Lyve Management Portal username and password in the Lyve Client app.
Once Lyve Client has validated permissions for the device connected to the computer, the LED on the
device turns solid green. The device is unlocked and ready for use.
Set up iSCSI
1. The iSCSI setup sequence can be initiated from the Activity or Devices screen. In the Lyve Client app,
click on the Activity or Devices tab.
Note—For Debian, it may be necessary to create a multipath.conf file in the /etc directory.

® ®
Important—The status indicator for detecting devices may run for a few minutes while
Lyve Client discovers Lyve Mobile Array.

86 Lyve Mobile Rackmount Receiver 7/26/22