Seagate Lyve Mobile Array, User Manual

Page: 36 / 117

4. Open Lyve Client. You may be prompted to unlock Lyve Mobile Array if this is the first connection to the
host.
5. Click the Devices tab.
6. Click on the Mobile Array card with the Rackmount Receiver » FC connection.
Lyve Client automatically completes your FC connection configuration.
Manual FC Setup
Typically, Lyve Client will configure FC connections for Mobile Array devices in Mobile Rackmount
Receivers. If an FC connection must be manually configured, refer to the following instructions.
1. Open Server Manager.
2. Open Computer Management.
3. Open Disk Management.
4. If more than one Offline drive exists, continue steps 5-9. If there's only a single Offline drive, go to step
10.
5. Open the Server Manager and install Multipath I/O (MPIO).
6. Open MPIO.
7. Click on the Discover Multi-Paths tab.
8. Click on the Seagate device to highlight it and click Add.
36 Lyve Mobile Rackmount Receiver 7/26/22