10
Revision 2.EL950 1.3.1074C 18.6
DOOR CLEARANCE
Allow 7” (18 cm) of clearance on the right side of the machine for the door to open and extend past the
cabinet side. See also the clearance requirements in Section 2 for refrigerated units.
LOADING PRODUCTS
To present your product in as an attractive and professional manner as possible, do not load any
damaged items, and make sure items are facing forward for easy identification by your customer.
Note: The size of the item being vended must be larger than the Helix Coil, but smaller than the
Product Column to vend correctly. Never force an oversized item into the Helix Coil or Product Column,
nor attempt to vend an item that is smaller than the Helix Coil as this will create problems and deter
customers. (Fig.5)
1.
To Load Product:
A.)
Push down and hold the release latch located on the right side of the tray and slide the desired
Product Tray toward you, all of the way forward. Product Tray will tilt down or can be removed and
placed on the floor or a table.
Note: Pull out only one (1) Product Tray at a time. Beverage trays do not
tilt for loading
B.)
Place product in proper size Helix Coil. Note: Bottom of product must rest on the Product Tray and not
on the Helix Coil. (Fig. 5) Load each
Product Chute from front to back. Note: Do not leave any spaces between items.
C.)
Once Product Tray is loaded, lift the front of the tray to level and push it back in. Repeat above steps
until all Product Trays are fully loaded.
D.)
After loading the product, if you have removed the tray to do so, place the
Tray in the cabinet by aligning the wheels in the guide rails. Clear the wire harness To the side so that it is
not interfering with the tray below.
Note:
We suggest that you always partially fill the vendor with product and perform at least five (5) test
vends. Test vends can be performed easily by entering Service Mode and using the Diagnostics/Motors to
select the selection to test.
Fig. 5 – Loading Helix Coils
Correct – load
product between
Helix Coils, resting on
the product tray.
Correct – load product between Helix
Coils, resting on the product tray.
Helix Coil
Product Tray
Columns
Incorrect
Incorrect
