SeaDoo 2006 GTI, Shop Manual

Page: 630 / 801

Section 13 PROPULSION
Subsection 01 (JET PUMP)
NOTE: If jet pump housing rest against a table,
raise it slightly to allow complete shaft insertion
with the shaft guide.
Remove shaft guide.
Impeller
Apply anti-seize (P/N 293 800 070) on threads of
impeller shaft
no. 11 .
F00J0GA
1
1. Apply anti-seize on threads
Using 2 screws previously removed from venturi,
secure impeller shaft holder tool (P/N 295 000 082)
to housing.
Install shaft holder tool in a vise.
F00J0HA
1
1. Impeller shaft holder secured in a vise
To ease impeller installation, apply BOMBARDIER
LUBE lubricant on wear ring.
Insert impeller into wear ring. Manually rotate im-
peller and push so that it slides on impeller shaft
threads. Carefully engage threads making sure
they are well aligned.
Install impeller remover/installer tool into impeller
splines and tighten.
F00J08A
1
1. Impeller remover/installer tool
CAUTION: Make sure thrust washer and bear-
ing are not wedged in shaft groove. To check,
manually pull and push jet pump housing,
some axial play must be felt.
Torque impeller to 80 N•m (59 lbf•ft) then remove
tools.
CAUTION: Never use any impact wrench to
tighten impeller.
Apply synthetic grease (P/N 293 550 010) on im-
peller splines.
Insert a new boot no. 2 and ring no. 3 to impeller.
F00J10A
1
1. Boot and ring
630
smr2004-Complete Line Up
www.SeaDooManuals.net