Master Cabin
Double berth located on centerline forward. Shelves with lockers outboard at hull sides
with hanging locker immediately aft, port and starboard. On the cabins aft bulkhead
between the head and the forward end of the keel trunk is the cabin entrance door. On
the port side is the desk with the vanity immediately forward of this and the port side
hanging locker forward of the vanity. The AC outlet grille is located above hanging locker
door on the port side.
Master Cabin Heads
On the starboard aft side of the master cabin is the head compartment with separate
stall shower. The head is at the forward end of the compartment facing aft, basin with
countertop are located outboard of this with the separate shower stall aft of this. Head
and shower stall soles to have integral GRP sump trays with corner drains provided for.
Saloon
The aft facing U-Shaped settee and dining table to port has lockers and shelves
outboard and a countertop with drawers under immediately aft. On the starboard side is
an L-Shaped settee and coffee table with lockers and shelves outboard and countertop
with drawers under immediately aft, this countertop and locker will be dedicated as the
bar area. Storage is to be located behind the settee backs. AC units are located port and
starboard under countertop units aft of settees with outlet grilles above outboard lockers.
Galley
Galley is located on port side aft of saloon, galley is U-Shaped and facing forward. On
the outboard side is a counter top with locker and trash compactor under and a custom
fridge box on top, the stove is aft of this with the freezer box aft of this, also located on
the countertop, with the sinks adjacent to this between the engine box, over the engine
box on the inboard side is the micro-wave and counter top space.
These items are to be installed in a manner that is consistent with the surrounding
joinery and with reasonable access for service and maintenance. Builder is to insure
proper ventilation, venting, drains and installation according to the manufacturers
instructions.
All the above standard household equipment is to be modified so that it is acceptable for
an offshore yacht of this type which is subject to heeling, pitching, and rolling. Builder
shall install all necessary locks, catches, shelves, fiddles and rails.
Stove recess to be lined with stainless steel with insulation behind. Stove top to be
supplied with sea rails and pot holders. A stainless steel crash rail to be installed in front
of stove.
Engine Room
The engine room is to be fitted out in a proper manner in perforated aluminum sheet,
finished in Awlgrip, over the specified sound insulation. Inside of hull to be finished in
flow-coat to facilitate cleaning.
Shelves and bins to be fitted as allowed by space restrictions. All equipment, piping,
wiring and valves to be clearly labeled.
19
