Sea&Sea MDX-RX100/?, Instruction Manual

Page: 8 / 22

Prepare the digital camera
E-8
This product is exclusively designed for use with Sony
DSC-RX100/DSC-RX100M2 digital camera. Other cameras are not
compatible with this product.
This product is kept watertight by the O-ring.
To keep the O-ring functioning properly,
please observe the following before setting up.

Make sure to remove the O-ring when maintaining.

For detailed O-ring maintenance methods,
please see the O-ring maintenance manual.
Maintaining the O-ring

Make sure that there is sufficient battery power remaining and the image
storage medium has enough room for the number of pictures.

Remove the strap from the camera if any of these accessories are
attached.

Make sure the camera is operating correctly, referring to the camera's
instruction manual for details.
CAUTION

Make sure to fit/install the O-ring into the groove properly after maintenance.
Prepare the connecting accessories
When using external strobes, lights or other accessories in combination
with this product, prepare the equipment before setting up.

If the accessories are kept watertight by O-rings, make sure the O-rings
are properly maintained.

If the accessories are powered by batteries, make sure that there is
sufficient battery power remaining.

Make sure the equipment is operating correctly, referring to the instruction
manual provided with the equipment.
Preparation for Setting Up
O-ring
E-7
[With the RX-100M2]
[With the RX-100]
• Attach four rear cushion rubbers
(small) on the rear window (four
positions).
• Attach four rear cushion rubbers
(large) on the rear window (four
positions).
• Replace the wheel rubber
(small
→
large).
• Replace the mode dial rubber
(small
→
large).
Rear cushion rubber (large)
Rear cushion rubber (small)
Mode dial rubber
Wheel rubber
Mode dial rubber
Mode pulley
●
The mode dial rubber
should be fitted firmly
in the groove of the
mode pulley.
●
Push it in firmly as far as it will go.
(small) (large)
(small) (large)
Preparation for Setting Up
Prepare the housing
This product must be used in combination with the optional equipment
(digital camera, port, strobe, accessories etc.) for underwater photography.
In order to set up the equipment, prepare each item correctly.

The port on this product is built into the housing and thus cannot be removed.
CAUTION
●
Be sure to retain the replaced parts.