CUBE
READER NW
ENGLISH
REV.00
26
The factory default setting for the keypad heater is disabled, to
changing it:
1. Enter Programming Mode.
2. Press "6" to enter Menu 6: the Mode LED will flash green.
3. Construct the digit code
3 0 0
and the fourth digit as follows:
“0” to DISABLE the heater
“1” to ENABLE the heater
21. Replacing a lost Programming Code
NOTE:
The
CUBE
R. NW must be in Normal Mode otherwise this
will not work. Make sure that the Mode LED is green before
proceeding
1. Remove power
2. Press the
EXIT BUTTON
button
3. Apply power to the unit with
EXIT
button pressed
4. Release the
EXIT
button
5. Within 15 seconds :
enter programming mode by pressing # twice
insert the default programming code (see table in paragraph 8)
Press 3 to access the programming code modification function
Enter the new programming code.
6. The
CUBE
R. NW returns to Normal mode: the ‘Door’ LED
switches off and the ‘Mode’ LED turns green.
22. Replacing a lost Normal / Secure Code
NOTE:
The
CUBE
R. NW must be in Secure Mode otherwise this
will not work. Make sure that the Mode LED is red before proceeding
1. Remove power
2. Press the
EXIT
Button
3. Apply power to the unit with
EXIT
button pressed
4. Release the
EXIT
Button