3
6
Install a conduit from the transformer to the electrical
box.
Connect the white transformer wire marked “COM” to
the neutral power line wire with a wire nut.
Connect the black transformer wire marked “120V” or
the yellow transformer wire marked “boost” to the hot
power line wire with a wire nut (cap off the unused
boost or 120V tap with wire nut).
Use boost tap only if input voltage is below 110V or the
power supply is mounted in a remote location from the
lighting system more than 20 feet away.
Ground the transformer in accordance with local
electrical code.
24VDC
COM
120V
BOOST
1C
7
8
9
7
8
8
Check the System
COM X1
X2
X3
X4
PHILLIPS
SCREW
CIRCUIT BREAKER
After installing the entire system, operate the system for
five minutes.
The transformer circuit breaker will trip if there is a short
in the system. After removing the cause of the short, the
circuit breaker needs to be reset to power the system
up.
Replace the transformer cover and tighten the two
Phillips screws on the sides of the transformer.
2A
1
2
3
3
2
3
