Section 01 MAINTENANCE
Subsection 04 (SPECIAL PROCEDURES)
5290325002
WARNING
Certain components in the engine compart-
ment may be very hot. Direct contact may re-
sult in skin burn. Do not touch any electrical
parts or jet pump area when engine is run-
ning.
smr2009-015-001_a
1. Oil cooler coolant inlet hose
4. Continue to run the engine at 3500 RPM for 15
more minutes (20 minutes total run time).
5. Shut the engine off.
6. Remove the hose pincher on the coolant line
going to the oil cooler.
NOTICE
Hose pincher must be removed prior
to operating the watercraft. Failure to do this
will result in damage to the engine.
7. Change the oil and filter again.
8. Procedure is now completed.
CAPSIZED WATERCRAFT
Capsized for More Than 5 Minutes
Refer to
WATER-FLOODED ENGINE
in this sub-
section.
smr2009-015
13
Summary of Contents for GTX Limited iS 255 2009
