Sea-doo 2005 3D RFI, Operator'S Manual

Page: 51 / 123

PRE-OPERATION CHECKS

WARNING
The pre-operation check is very important prior to operating the water-
craft. Always check the proper operation of critical controls, safety fea-
tures and mechanical components, before starting as listed hereinafter. If
not done as specified here, severe injury or death might occur. Bring all
safety equipment required by local laws.
Some of the following items may not have been previously covered in this
guide, however they will be described in the MAINTENANCE or SPECIAL
PROCEDURES section. Please refer to these sections to have more detailed
information.

WARNING
Engine should be off and the safety lanyard should always be removed
from its post prior to verifying any of the following points. Only start wa-
tercraft once all items have been checked and operate properly.
ITEM
OPERATION
✓
Hull Inspect.
Jet pump water intake Inspect/clean.
Bilge Drain. Ensure plugs are secured.
Water flow in cooling system
(only when temperature is below
or close to freezing point) Check if water properly flows out at jet pump.
Battery Inspect tightness of cables and retaining
bracket(s)
Fuel tank and oil reservoir Refill.
Engine compartment Check fuel line connections for tightness.
Check for any fuel leak/odor.
Steering system Check operation and proper handlebar position.
Steering pole Check operation.
Throttle system
Check operation.
VTS (if so equipped) Check position and adjustment.
Safety lanyard and engine
start/stop button Check operation.
Optional configurations Check installation and settings.
NOTE:
See the detailed instructions hereinafter.
50
______________________
www.SeaDooManuals.net