If engine is not started within 5 sec-
onds after installing the safety lanyard
on its post, 4 very short beeps every 3
second interval will sound for approxi-
mately 2 hours to remind you to start
the engine or to remove safety lan-
yard. Afterwards, the beeps will stop.
The same will occur when safety lan-
yard is left on its post 5 seconds after
engine is stopped.
Always ensure safety lanyard is not
left on its post after engine is stopped.
IMPORTANT
: Leaving the safety lan-
yard on its post when engine is not
running will slowly discharge the bat-
tery.
Digitally Encoded Security
System (DESS
TM
)
The safety lanyard cap specifically con-
tains an electronic circuit that gives it a
unique electronic serial number. This
is the equivalent of a conventional key.
This safety lanyard cannot be used on
another watercraft and conversely, the
one from another watercraft cannot be
used on your watercraft.
However, the DESS brings a great flex-
ibility. You can buy an additional safety
lanyard and have it programmed for
your watercraft.
To have additional safety lanyard, refer
to an authorized Sea-Doo dealer.
2) Handlebar
The handlebar controls the direction of
the watercraft. Turning the handlebar
to the right steers the watercraft to the
right and inversely.
WARNING
Check handlebar and correspond-
ing steering nozzle operation be-
fore starting. Never turn handle-
bar while someone is nearby rear
of watercraft.
Keep away from
steering
moving
parts
(nozzle,
linkage etc.).
This watercraft features the O.T.A.S.
system. Refer to THROTTLE LEVER
for more information.
3) Handlebar Adjuster
WARNING
Always stop engine and bring wa-
tercraft to a complete stop before
adjusting handlebar.
The handlebar is adjustable to suit
driver's
preferences
when
driving
watercraft depending on the configu-
ration installed and used.
Lift the adjuster and hold while mov-
ing handlebar to the desired position.
When handlebar is in position, release
adjuster.
There are 3 positions. Notice that in
the rearward position it is appropriate
to use your index finger to activate the
throttle. In the forward position, the
thumb is more appropriate.
Notice there are 2 start/stop buttons.
Use the button that is the most appro-
priate to you. Practice its use before
riding the watercraft.
WARNING
Prior to using the watercraft:
- Ensure handlebar is properly ad-
justed and locked.
- Locate and practice using start/
stop button.
_____________________
31
www.SeaDooManuals.net
Summary of Contents for 2004 3D RFI
