58
Towing the
Watercraft
in
Water
Special precautions should be taken
when towing a Sea-Doo watercraft in
water.
Maximum recommended towing speed
is 24 km/h (15 MPH).
When towing your watercraft in water,
pinch the water supply hose from the
impeller housing to the engine with a
large hose pincher (P/N 529 032 500).
This will prevent the cooling system
from filling which may lead to water
being injected into and filling the ex-
haust system. Without the engine run-
ning there isn’t any exhaust pressure
to carry the water out the exhaust out-
let.
CAUTION:
Failure to do this may re-
sult in damage to the engine. If you
must tow a stranded
watercraft
in
water and do not have a hose pinch-
er, be sure to stay well below the
maximum towing speed of 24 km/h
(15 MPH).
Snugly install the hose pincher on the
water supply hose as shown.
GS, GTS AND GTI MODELS
1. Hose pincher
RFI MODELS
1. Hose pincher
CAUTION:
When finished towing
the watercraft, hose pincher should
be removed before operating it. Fail-
ure to do so will result in damage to
the engine.
Low-Charge Battery
Condition
See an authorized Sea-Doo dealer to
have it charged or replaced.
F01B23Y
WARNING
Do not charge or boost the battery
while installed on the watercraft.
F02E04Y
1
F07E04Y
1
smo2001-002a.book Page 58 Wednesday, June 7, 2000 3:57 PM
www.SeaDooManuals.net
Summary of Contents for 2001 GS 5548
Page 1: ...www SeaDooManuals net ...
Page 100: ...www SeaDooManuals net ...
