7
Spray BOMBARDIER LUBE lubricant
into air intake silencer keeping engine
at fast idle.
1. Air intake silencer
2. Pull plug
3. Spray BOMBARDIER LUBE here
NOTE:
Lubrication of engine should
be done for at least 1 minute. Close
the water tap then stop the engine.
Disconnect the garden hose.
Wipe up any residual water from the
engine.
Remove spark plug cables and con-
nect them on the grounding device.
1. Grounding device
Remove both spark plugs and spray
BOMBARDIER LUBE lubricant into
each cylinder.
NOTE:
For the storage period, use
Bombardier storage oil (P/N 413 711
600).
Fully apply the throttle lever then de-
press the start/stop button to crank
the engine a few turns to distribute
the oil onto cylinder wall.
NOTE:
No fuel is injected in the en-
gine when the throttle lever is fully ap-
plied then the starter activated.
Apply anti-seize lubricant on spark
plug threads then reinstall them.
Reinstall plug on air intake silencer
cover.
NOTE:
Engine fogging should be
done whenever the watercraft is to be
stored for a few days or a long period.
SPECIAL PROCEDURES
Submerged Watercraft
If the watercraft is submerged and en-
gine is water-flooded, it is strongly rec-
ommended that the watercraft be ser-
viced by an authorized dealer imme-
diately.
In the event the engine cannot be ser-
viced within a few hours, remove
spark plug cables and connect them
on the grounding device.
-
CAUTION
Always close the water tap be-
fore stopping the engine.
◆
WARNING
Always use spark plug cable
grounding device when remov-
ing spark plugs.
F01F25Y
3
2
1
F07H0AY
1
smo9803a.fm5 Page 7 Friday, February 20, 1998 3:41 PM
www.SeaDooManuals.net
