LUBExpert User Manual
38/52
Of course, once you add it to your Work Order/Survey, there will be Dynamic point only to perform
grease replenishment through
You will choose Dynamic settings, work through your task as explained before and, once finished,
you will download data to your UAS3.
At that point, Static settings in your node will be automatically created in UAS3, all settings properly
copied, and point will be populated with data.
This is very practical way, and it will most probably be your choice.
NOTE!
Alarms can be assigned to Static settings only, but even if Static settings are not transferred to Work
Order/Survey, Dynamic settings will be affected by defined thresholds and alarms will be fully
functional during field work.
During your lubrication process, all messages will be precisely time stamped and marked as ones
automatically added or ones manually added. That way, full control and traceability of work is
obtained.
If in
GUIDED MODE
, you will be provided precise instructions and Lubrication status at every step.
In
FREE MODE
, you can perform lubrication at your own assessment, with all necessary information
on your display. Lubrication status and outcome of you work will be added in UAS3
Quantities of added grease will be recorded in all cases.
Alarm status (if assigned) will be refreshed with every step in the process.
9.4.
Transfer Results to PC
Upon completion of the lubrication survey connect your LUBExpert or SDT270SU/DU to your PC’s
USB port to download the results. Follow these steps: