TB-9031
Page 1 of 4
© 2015 DESCO INDUSTRIES, INC.
Employee Owned
SCS
- 926 JR Industrial Drive, Sanford, NC 27332 • (919) 718-0000 • Website:
StaticControl.com
Workstation Monitor Checker
Installation, Operation and Maintenance
August 2015
USER GUIDE TB-9031
Figure 1. SCS CTE701 Workstation Monitor Checker
Description
The SCS CTE701 Workstation Monitor Checker
verifies the proper operation of the SCS
WS Aware
Workstation Monitor
, SCS
Ground Master Equipment
Ground Monitor
, SCS
Iron Man Plus Workstation
Monitor
and SCS
Ground Man Plus Ground Monitor.
The Workstation Monitor Checker simulates resistance,
impedance and voltage signals so that you can see
whether the response of your monitors complies with
your specifications. It meets the ANSI/ESD S20.20
requirements for compliance verification of continuous
monitors.
The Workstation Monitor Checker presents certain
loads and signals to the monitor that simulate specific
parameters of ground connections and wrist straps.
The Workstation Monitor Checker is available in one
model:
Item
Description
CTE701
Workstation Monitor Checker,
with 9V Alkaline Battery
Packaging
1 Workstation Monitor Checker
1 9V Alkaline Battery
1 Ground Cable (banana to alligator clip)
1 3.5 mm Male to Male cable
Features and Components
Figure 2. Workstation Monitor Checker features and
components
The Workstation Monitor Checker uses a 9V alkaline
battery. Make sure that a fresh battery is installed prior
to performing any test. If you are not planning to use
your Workstation Monitor Checker for a long time, please
remove the battery from the device.
Basics
For all tests make sure that:
• Monitor under test is properly grounded and is
operational.
• Disconnect all wires from the monitor under test that go
to the monitored grounds. Leave ground connection of
the monitor connected to a known good ground.
Made in the
United States of America