6 Commands
Unproto possibilities for PACTOR-III:
Parameter Speedlevel
Packet
definition
30: 1
short
cycle
31: 2
short
cycle
32: 3
short
cycle
33: 4
short
cycle
34: 5
short
cycle
35: 6
short
cycle
36: 1
long
cycle
37: 2
long
cycle
38: 3
long
cycle
39: 4
long
cycle
40: 5
long
cycle
41: 6
long
cycle
If no argument is given, then the PTC-IIex uses the mode that was last used, or the default
setting. The actual mode is shown on the LED status field.
The Unproto mode may be terminated with a QRT character, a
Disconnect
. It is
always possible to abort a unproto transmission using the command
DD
.
A repetition rate of 3 does not mean that the text appears on the screen of the receiving
station 3 times. In this case, the PTC increases the redundancy of the signal by repeating
it. The transmission takes longer, but there is a correspondingly greater chance of
receiving it correctly. At the receiving station, once a packet is correctly received, it will
not be received again. A data packet may be repeated 3 times, but will only appear once
at the receiving station(s). It is recommended that the repetition rate should be adjusted
according to propagation conditions. A greater repetition rate, and lower baud rate, for
poor conditions, and conversely a lower repetition rate, and higher baud rate, for better
conditions.
After approximately 4 minutes of idle transmissions, an automatic QRT is carried out.
6.101
UPDATE
The
UPDATE
command renews the PACTOR firmware in the Flash ROM of the PTC-
IIex. It should only be used together with the corresponding program on the PC.
6.102
USer
Remote
The
User
command enables an overview of all presently operating PTC-IIex links. Here
the PTC-IIex gives out the callsign of the opposite station, as well as the digipeater list
etc. In contrast to the
CStatus
command in the
pac:-
menu, the
User
command also
lists an operating PACTOR link, under channel number 0. (This channel is free, as the PR
channel 0 only serves as a
monitor channel
and thus no link is possible).
85
Summary of Contents for PTC-IIex
