SCS PTC-IIex, Manual

Page: 70 / 220

6 Commands
The PTC contains a short description of every command, so that the manual does not
need to be continually consulted. These descriptive messages can be obtained by using
Help
, followed by the required command.
Help bau (or in shortened form h bau.)
From remote,
Help
results in only those commands that can be remote controlled being
listed. A thorough description of each command can also be obtained by the remote
station, using
Help
<CMD>,
Help
phase or
Help
bell.
6.45 LFignore
Default setting: 1
Parameter: 0 no insertion of <LF>.
1 insertion of <LF> after each <CR>.
2 multi-<CR>-supression
LFignore
determines whether a <LF> is automatically appended to each <CR> that is
sent to the terminal. For
LFignore
0 the characters are passed exactly as the PTC
receives them. For
LFignore
1 <LF>'s sent to the PTC are ignored (refer also to
command
ADdlf
, chapter 6.2 , page 37 ).
LFignore
2 activates in addition the multi-CR suppression with RTTY and
AMTOR/FEC reception. (Multiple <CR> in a row without other characters between are
suppressed except for the first <CR>. In the EOL (End Of Line) sequence in some US-
American controllers, <CR><CR><LF> no longer causes an unwanted empty line. A
number of commercial RTTY services (e.g. Meteo services) also still use the historical
double-CR at the end of every line. These services can be better copied when LF=2.
6.46 LICENSE
Default setting: none
Parameter: X License key.
The
LICENSE
command is to enter or to readout (if already entered previously) the
License key which enables extended (professional) firmware functions.
The following messages will be returned by the PTC-IIex, depending on licensing status:
If the license is invalid:
LICENSE: NOT OK, XY TRIAL CONNECTS REMAINING
Whereby
XY
is the number of remaining test connects.
If a valid serialnumber license is installed:
LICENSE: SERIALNUMBERXYZO ABCDEFGHIJKL
The following operating modes are subject to be licensed:
•
PACTOR-III connections.
56