
SCROOSER GmbH
All rights reserved.
38
How to charge the battery:
1.
Connect the charger connector to the charger socket.
Caution: the connector is magnetic. Make sure you are inserting the connector the right way round.
Figure 15: charger or similar model.
2.
Plug the charger power cable into an earthed socket.
When you have successfully connected the charger to the mains, the red LED on the charger will
light up. When the battery is fully charged, the LED will change colour from red to green. The battery
will automatically stop charging once it is full (green LED). It takes approx. three to five hours to
charge a fully depleted battery.
3.
Detach the charger connector from the battery.
Caution: when detaching the charger connector, always hold the connector itself rather than the
cable.
How to put the battery back in after charging:
1.
Reinsert the fully charged battery, and connect it to the Rosenberger connector.
Caution: the Rosenberger connector is magnetic. Large or small pieces of metal may get stuck to the
connector. Check that the connector is clean before connecting it to the battery:
2.
Then fold the horizontal footboard back down and lock it using the key supplied with the
SCROOSER.
If you do not use the SCROOSER for a prolonged period of time, the battery will go into sleep mode.
The SCROOSER will not start while the battery is in this mode. If this happens, press the battery
charge display on your battery once so that the green LEDs light up. This will reactivate the battery.
You can also reactivate the battery by connecting the charger.
Putting the battery back in
Reactivating the battery from sleep mode