Scout MT-700 ENT, Operation Manual

Page: 42 / 155

МТ-700 fleet tracking system 42

Remote configuration
The remote configuration is carried out through the “SCOUT-Server”, which is used to send
data by the terminal.
Figure 39 Launching window of the “SCOUT Configurator”. Remote connection
Software “SCOUT Configurator” connects to the “SCOUT-Server” and sends an assignment
for the configuration or terminal state request. The server is waiting for the next
communication session, after which, it sends the commands to the terminal and sends the
execution result to the Configurator.
“SCOUT Server” does not initiate the connection with the terminal; therefore, the
tracker’s has to connect to the server to remotely configure.
Correct settings (server name, APN settings, and others) should be specified.
If the tracker is inside an area with low GSM-signal, or has data accumulation settings,
then the commands implementation can be delayed.
Remote connection to the tracker should be carried out in the following order:
1. Launch the “Universal SCOUT Configurator” software.
2. At the launch screen, choose the “Remotely” option.
3. In the dropdown list choose the required profile. If this is the first connection then click
“Settings” to create a new profile.
4. Select the line with the needed terminal and click the “Settings” button.
5. The following configuration should be performed according to the instructions on the
“SCOUT Configurator” operation.