Scotchman B2153NF, Manual, Page: 49 / 86

Page 48
7.4 DISCHARGE TRACKS WITH SCALES
Roller discharge tracks equipped with either a right or left hand quick-loc are available in two lengths:
60" and 120" (122 & 303 CM).
The discharge tracks mount to the machine in place of the 30 inch (76 CM) stop that was provided with
the machine. The discharge tracks allow fast set-up and accuracy for various lengths of cuts.
SEE FIGURE 21 ON THE FOLLOWING PAGE.
1. Bolt the support bracket (A) to the side of the base casting with the 10 x 30mm head bolts and
lock washers provided.
2. Bolt the legs (B) to the rail assembly (C) with the remaining 10 x 30mm hex head bolts.
3. Place the two remaining 10 x 80mm hex bolts through the end of the rail assembly and lock them
in place with the hex nuts.
4. Thread another nut on each bolt and attach the track to the support bracket with the remaining
two 10mm hex nuts.
5. Space the rollers along the rail at an even spacing.
6. Adjust the discharge track so that the rollers are at the same level as the bed of the material vise
on the saw. The track is adjusted by loosening the bolts in the legs and the two bolts that attach
the rail to the support bracket.
7. After a discharge track is mounted, the scale should be calibrated. To do this, draw the saw head
down and set the quick-loc extension (6) ten inches from the blade. Install the scale so that the ten
inch mark lines up to the quick-loc pointer. When the quick-loc extension (5) is used, you have to
add ten inches to the length of the part that you want to cut. If the stop requires fine adjustments,
remove the quick-loc handle from the track and turn it over. There is a fine adjustment on the
bottom side of the quick-loc handle.