6.0 MACHINE OPERATION
CAUTION: MAKE SURE ALL COVERS ARE CLOSED
The switches are located on the right side of the Support Pillar.
To START the machine, push the GREEN button.
To STOP the machine, push the RED button.
REFER TO SECT. 5 SEE FIGURE 6
6.1 STARTING AND STOPPING BELT
6.2 DRIVE FOR THE GRINDING BELT
A pulley with a rubber coating is mounted on the motor shaft. The rubber coating, in combination
with the correct belt tension, ensures the required grip of the grinding belt to the pulley.
The direction of rotation is indicated on the pulley. When starting the machine, make sure the
pulley turns in the right direction. If not, see NOTE at the top of FIGURE 5.
The direction of rotation is also indicated on the inside of the grinding belt.
This must match the arrow on the pulley.
6.3 SECURING A TUBING SECTION
The clamp for the tubing has V-shaped side plates on the left side and is suitable for clamping
tubing with a diameter of 18 - 76 mm (3/4 - 3 in).
ITEM 6 in FIGURE 7 and in FIGURE 8 is the handle to operate the tubing clamp.
When the V-shaped side plates are removed, the tubing clamp can also be used to secure
rectangular and square tubing. In the case of rectangular and square tubing, the center of the
tubing profile must be at the same height as the center of the grinding roller. To achieve the
correct height of the tubing profile, a fill block can be used under the tubing section.
ITEM 7 in FIGURE 7 and in FIGURE 8 shows an allen bolt that is used to set the angle of tubing
clamp. There is also another bolt (not shown) in the center of the clamp.
6.4 ANGLE ADJUSTMENT
PAGE 23