4.2 ASSEMBLING MACHINE & MOVING
PAGE 13
ASSEMBLING OVERVIEW
This grinder/notcher machine is shipped unassembled in a wooden crate.
There are basically four parts. See FIGURE 3 on the next page.
FOOT PLATE: This is a 1 inch thick by 19-1/2 inch square metal plate that sits on the floor.
SUPPORT PILLAR: This is the rectangular "box" that mounts to the Base with 4 bolts and washers.
PLATE: This is a flat rectangle shaped plate that mounts on top of the Column.
GRINDER: This is the main part of the machine. It mounts on top of the Column and Plate
with two bolts and washers. It has a "Lifting Eye" that is used for moving it.
ASSEMBLY & MOVING BOTH MODELS
• Remove loose components from the packaging. Inside the support pillar you will find a box with any
ordered grinding belts and grinding rollers, the grinding waste container, the ball handle, the handle,
and the attachment hardware.
• Remove the two attachment bolts with which the universal pipe notcher is attached to the bottom
plate of the packaging.
• Remove the wood screws with which the support pillar and foot plate are attached to the crate.
• Remove the support pillar from the packaging and bolt them together with (4) bolts and washers.
• Remove the machine from the packaging. To do so, use the Lifting Eye Shown in FIGURE 3. Use the
proper lifting equipment as this machine weighs 200 kg (440 lbs).
• Open the side cover of the machine and attach the machine to the support pillar - with the plate in
between them - using two M12 hex bolts.
• Slide the grinding waste container under the machine.
• Install the included ball handle on the front of the cross support.
•Install the included lower handle under the cross support.
NOTE: The ALU100-02 is operated with (2) round aluminum hand-wheels. However,
the lower handle for under the cross support is supplied with this machine. The larger in
feed wheel and it's spindle must be removed in order to use it.