IMPORTANT NOTE:
If vehicle is equipped with XM tuner box (active or not
active) the BFGMLANXMB harness must be used. The BFGMLANXMB “T”
harness must be installed at the SAT radio Tuner box location.
XM TUNER LOCATIONS:
Trucks/SUVs: Behind Glove box, Crossovers: Left
rear side panel, Sedans: Trunk.
TECH TIP:
Do not mount the BFCL2 module near moving or mechanical de-
vices that may damage the interface. Keep away from any hot surface areas like
heater ducts, direct sun light and metal surface areas that may get hot.
BFCL2 INTERFACE INSTALLATION
1. Locate XM tuner box in vehicle.
2. Remove harness from the XM tuner.
3. Install BlueFusion “T” harness
into the XM tuner.
4. Plug the 24 pin connector into
the BFCL2 BlueFusion interface.
IMPORTANT NOTE:
When vehicle is NOT equipped with XM tuner box, the
BFCL2HB harness must be used. The BFCL2 “T” harness must be installed
behind the vehicle’s stereo.
TECH TIP:
Do not mount the BFCL2 module near moving or mechanical
devices that may damage the interface. Keep away from any hot surface areas
like heater ducts, direct sun light and metal surface areas that may get hot.
NON-XM INSTALLATION:
1. Remove the factory radio.
2. Remove the 12 and 24 pin
connectors from the factory radio.
3. Use T-taps to connect the power
and ground wires.
4. Plug the factory 14 and 16 pin
connectors into (2) BFCL2HB
female harnesses.
5. Plug the (2) BFCL2HB male
harnesses into the factory radio.
6. Plug the 24 pin connector into the
BFCL2 BlueFusion interface.
VEHICLES WITH SAT TUNER
VEHICLES WITHOUT SAT TUNER
3
XM HARNESS
MICROPHONE
24-Pin
3-PIN
XM TUNER
BOX
CAR HARNESS
BUIL
T IN
FIL
TER BO
X
NON XM HARNESS
MICROPHONE
24-Pin
3-PIN
FACTORY
RADIO
FACTOR
Y HARNESSES
POWER
GROUND
