Scooterpac Invader, User Manual

Page: 27 / 44

Scooterpac Invader | User Manual 27
9.12 Charging the Invader
After using your Invader it will need to be recharged. The Invader is supplied with a
charger that can be plugged into a regular 3-pin power socket outlet. The charging port
on the Invader is located and the seat, between where your legs would rest.
When the charger is plugged in the wall and not into the Invader the light will appear
green. To begin charging, plug the charger into the Invader’s charging port (see fig 13).
The charger LED will turn red.
After the Invader is fully charged the LED on the charger will turn green. You can unplug
this from the Invader. You can charge the unit at any point of its usage. The Invader
does not need to be fully discharged before charging again. From low voltage to full the
Invader can take between 8-10 hours to fully charge.
*
PLEASE NOTE* – Do not leave the charger plugged in for extended periods of time after it is finish as it will ruin the battery
life and can possibly become a fire hazard.
*PLEASE NOTE* – For best practice, please ensure to charge your batteries after each use. Do not overcharge your batteries,
the charger should be connected for now more than 12 hours continuously. If there are long periods where you decide not to
use your scooter, we recommend that batteries are charged at least once a fortnight. This will ensure they remain healthy and
are ready for regular usage.
Figure 17 – Charging port