Maintenance and care
62
03.00|WDP-5X |en
Maintenance and care
The clamping systems for the workpiece direct clamping VERO-S
WDP-5X and the quick-change pallet systems VERO-S WDP-5X-
DSM 99-70, WDP-5X-ASM 99-70-Ø36 are designed for low-
maintenance operation, meaning it is only necessary to open and
disassemble the clamping systems and clamping modules in
exceptional circumstances.
CAUTION
Risk of injury and risk of damage to the clamping module when
opening the housing cover.
If the clamping module has to be disassembled, send the
module to SCHUNK for repair.
The covers of the clamping modules are spring preloaded and
must only be removed by trained specialist personnel. The
covers of the WDP-5X-DSM 99-70 direct clamping module and
the WDP-5X-ASM 99-70-Ø36 compensation module may also
only be assembled and disassembled in compliance with the
corresponding assembly and disassembly instructions.
To ensure the quick-change pallet system operates perfectly, the
following instructions are to be observed:
Pressure medium: compressed air, compressed air quality
according to ISO 8573-1:7 4 4.
CAUTION
A separate maintenance unit with oiler must be used for the air
supply.
Ambient conditions and operating conditions
•
Make sure that the contact surfaces of the interface are always
clean.
•
Always ensure that no chips of any kind enter the interface of
the change components.
•
Only use high-quality cooling emulsions with anti-corrosive
additives during processing.
8
8.1
