Assembly
NOTE
If the media transfer function is used, ensure that the coupling
elements are depressurized and ventilated when loading and
unloading the clamping pallet. The NSE-A3 138-V4-P1 model has
open media transfer sleeves made of rubber. The interface
drawing for the clamping pallet side can be requested from
SCHUNK.
Before starting the machining process, ensure that the change
unit is resting flat on the bearing surface of the quick-change
pallet system and is locked.
Connecting hose lines
If several quick-change pallet systems are activated via one jointly
connected hose line, feed lines with the following minimum cross-
sections must be used.
Number of modules
At least nominal hose width
1
4 mm
2, 3, 4
6 mm
from 5
8 mm
When disconnecting hose lines, the relevant openings of the air
supply connections must be protected with seal plugs or sealing
caps to prevent the ingress of dirt or coolant.
Removal from the installation space
Detachable threads facilitate removal of the modules from the
installation space of the clamping stations. To pull off the clamping
module out of the installation space, two levering tools (e.g. long
cylindrical screws) are screwed diagonally into the two available
internal threads of the mounting holes.
5.3.1 Mounting
Mounting in the installation space is with 6 M8 screws for the
version without torque pin V4, or with 5 M8 screws and a fitting
screw for the version with torque pin V4.
The assembly module can be positioned by means of two
centering diameters of the installation space:
Ø 110 H6
in the lower range. For partial and full installation.
Ø 138 H6
in the upper range.
Positional orientation for modules with torque pin V4 is achieved
with a fitting screw with a diameter of Ø 9 f7 x 5 mm. In order to
do this, make a Ø 9 H7 hole at a distance of 60.5 +/- 0.01 mm from
the axis of the centering diameter (Ø110 H6 / Ø138 H6) on the
mounting bolt circle.
23
05.00 | NSE-A3 | VERO-S quick-change pallet system | en | 1376941
