Assembly
5 Assembly
5.1 Pre-assembly
Request our installation drawings if installing the module in the
customer's clamping stations yourself.
The installation position must be observed when performing the
installation yourself.
1
Partial installation
2
Do not use
3
Full installation
NOTICE
With installation location 2, the clamping slide can be blocked
by chips and dirt. For this reason, do not use this installation
position. Otherwise make sure to fit deeper clearance in front of
the movable clamping slides.
•
Damage to the clamping module is possible.
5.2 Installing and connecting
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
•
Before starting any work on the product: Switch off the power
supply and secure against restarting.
•
Make sure, that no residual energy remains in the system.
WARNING
Risk of injury due to unexpected movements when installing
and removing the cone seal!
This can cause components to move unexpectedly when working
on the cone seal, resulting in injuries.
•
Before starting all work on the product, refer to the cone seal
chapter. Link Fehlerbehebung
•
Make sure that components of the gate unit are fitted in
accordance with the installation guidelines and safely locked
in place.
19
05.00 | NSE-A3 | VERO-S quick-change pallet system | en | 1376941
