Maintenance and care
8.5 TOOLFIX MONO or VARIO tool adapter - Capto
Monthly: Visual inspection and cleaning of the quick-change
interface (1)
Clean and inspect the quick-change interface (1) of the tool
adapter. In case of damage or heavy wear, the interface must be
replaced (only necessary for adapters of the VARIO series).
Monthly: Cleaning and visual inspection of the toolholder
mounting interface (2)
Clean and inspect the toolholder mounting
interface. In case of damage or heavy wear, the tool adapter must
be replaced.
Monthly: Functional check of the tool locking mechanism (3)
Make sure that the tool locking mechanism (3) is completely
screwed in. To do this, turn it clockwise and tighten it. To check
the function, pull the tool locking mechanism (3) several times to
the rear and front end positions and release it. It must be possible
to pull the pin completely out of the toolholder mounting interface
(2). After releasing, the pin must snap automatically to the inner
end position and must not rebound from this position. The pin
must remain axially free from play in the inner end position. It
must be possible to pull the pin with two fingers (easily).
37
01.00 | | TOOLFIX modular tool mounting device | en | 1510829
