Translation of the original declaration of incorporation
46
04.00 | KSP3, KSP3-LH, KSP3-F | TANDEM Clamping Block | en | 1463318
10 Translation of the original declaration of
incorporation
in terms of the Directive 2006/42/EG, Annex II, Part 1.B of the European Parliament and of
the Council on machinery.
Manufacturer/
Distributor
H.-D. SCHUNK GmbH & Co. Spanntechnik KG
Lothringer Str. 23
D-88512 Mengen
We hereby declare that on the date of the declaration the following partly completed
machine complied with all basic safety and health regulations found in the directive
2006/42/EC of the European Parliament and of the Council on machinery. The declaration
is rendered invalid if modifications are made to the product.
Product designation:
TANDEM clamping force block, pneumatic
Type designation:
KSP3, KSP3-LH, KSP3-F
ID number
1382588, 1409254 - 1409257, 1409263 - 1409265, 1409267 -
1409274, 1409277 - 1409284, 1409287 - 1409290, 1409295 -
1409298, 1409300 - 1409303, 1409307 - 1409314, 1409321 -
1409324, 1409334 - 1409337, 1409342 - 1409353, 1409358 -
1409361, 1433619 - 1433622, 1433636 - 1433639, 1433654 -
1433657, 1433664 - 1433667, 1433671 - 1433674, 1433682 -
1433685, 1433689 - 1433692, 1433695 - 1433698, 1433701 -
1433704, 1433718 - 1433721, 1433724 - 1433727, 1433756 -
1433759, 1433812 - 1433815, 1433818 - 1433825, 1409277 -
1409279, 1409316 - 1409319, 1409325, 1409327 - 1409329,
1409354 - 1409357, 1409365 - 1409368, 1433775 - 1433777,
1433779, 1433785 - 1433788, 1433793 - 1433796, 1496888,
1496889, 1496930 - 1496939
The partly completed machine may not be put into operation until conformity of the
machine into which the partly completed machine is to be installed with the provisions of
the Machinery Directive (2006/42/EC) is confirmed.
Applied harmonized standards, especially:
DIN EN ISO
12100:2011-03
Safety of machinery - General principles for design -
Risk assessment and risk reduction
DIN EN ISO
4413:2011-04
Hydraulic fluid power – General rules and safety requirements for
systems and their components
DIN EN ISO
4414:2011-04
Fluid technology – General rules and safety requirements for
pneumatic systems and their components
The manufacturer agrees to forward on demand the relevant technical documentation for
the partly completed machinery in electronic form to national authorities.
The relevant technical documentation according to Annex VII, Part B, belonging to the
partly completed machinery, has been created.
Person authorized to compile the technical documentation:
Philipp Schräder, Address: see manufacturer's address
Mengen, December 2022
p.p. Philipp Schräder; Head of Engineering Design
