Assembly/Function
18
02.00|KSPplus-BWM KSP-LHplus-BWM |en
Connecting the clamping block
Make sure, that the power supply is off when connecting the
clamping block. See Chapter "Basic Safety Notes"
NOTICE
Risk of workpiece loss and damage to system from loss of air
pressure caused by damaged pneumatic lines!
Always make sure the connections are tight, and use appropriate
protective covers to protect the pneumatic hoses or lines from
hot chips.
Connecting the clamping block
The clamping block has four air connections:
I, II, III, IV
.
Two connections for OPEN (
I
and
III
) and two connections for
CLOSED (
II
and
IV
).
Which of the two hydraulic connections has to be opened for
actuation depends on the application:
• Connections
I
and
II
for operation without a base plate
7.2
