Assembly
01.00|SWS-001 |en
19
Manual Uncouple SWK and SWA
It is possible to manually uncouple the SWK and SWA if air is com-
pletely lost. This is not standard procedure and should only be use
when no other alternative is available.
NOTICE
If the tool is attached to the master it must be secured in the
tool stand or in a location where the tool weight is supported
before manually uncoupling. Use of manually uncoupling is re-
stricted to contingency situations.
Using the manual override will release the tool and may cause
damage to equipment.
• Do not manually uncouple the SWK and SWA if the tool is not
secured.
Manual Uncouple Master and Tool Plates
1 Remove the Unlock air tubing.
2 Unscrew the M3 elbow fitting from the SWK.
3 Using a 1.5mm Ball end Allen wrench, insert it through the Unlock
air port and push the locking piston to the unlocked position.
4 Separate the SWA from the SWK, supporting the SWA and tool
if attached.
6.3.3
Summary of Contents for SWS-001
