Troubleshooting
03.00 | Clamping Device SVP-2 | Assembly and Operting Manual | en | 0289021
23
7.3 Tool cannot be removed from the toolholder
Possible cause
Corrective action
Frictional corrosion / contact corrosion
Actuate clamping device on release pressure
for the toolholder. Drive out the tool shank
using a hammer and a suitable drift punch.
Clean clamping bore and tool and carry out
new clamping procedure.
Stickers or the like on the clamping area
Keep clamping area clean at the outer
diameter. It must be possible to seat the
reduction insert properly.
Laser inscription located on tool shank.
Remove or smoothen inscription on the shank
with a fine emery paper or a grinding stone.
Tool broke off.
Actuate clamping device on release pressure
for the toolholder. Drive out the tool shank
using a hammer and a suitable drift punch.
Clean clamping bore and clamp new tool.
