Assembly
28
05/STM-48V/en/2011-04-01/CW
Align the zero point markings of the rotor and the base body
so that they are at right angles on top of each other.
Select the position of the STM in the machine so that the zero
pulse is in the middle of the moving range.
Figure 5 Zero pulse alignment
Item
Description
/1/
Zero point markings on rotor and base body
/2/
Maximum possible moving range
Table 15
The interfaces to the attachments are clean and not dam-
aged.
The module is mounted to the machine via the corresponding
interface. Six fastening screws are required for each fastening
side. (see Figure 6, page 29)
Assembly
