Basic safety notes
10
05/STM-48V/en/2011-04-01/CW
2
Basic safety notes
2.1
Intended use
The STM was designed to rotate loads, workpieces and objects.
The STM may only be operated in combination with a controller.
The module is intended for installation in a machine. The re-
quirements of the applicable guidelines must be observed and
complied with.
The module may be used only in the context of its defined appli-
cation parameters.
Any other use or use exceeding that specified is an infringement
of use for intended purpose. The manufacturer bears no liability
for damage resulting from such use.
To use this module as intended, it is also essential to comply with
the manufacturer's specifications regarding commissioning, as-
sembly, operation and ambient conditions.
2.2
Environmental and operating conditions
The module may be used only in the context of its defined
application parameters (see chapter 5, page 17 and catalog).
Make sure that the module's range of application is outside
the explosive area.
Make sure that the environment is clean and the ambient
temperature corresponds to the specifications per the catalog.
Make sure that the environment is free from splash water and
vapors as well as from abrasion or processing dust. Excepted
are modules that are designed specially for contaminated
environments.
