Mounting
03.00|1341130_ROTA NCR-A |en
35
Switching the compensating clamping on and off
The item numbers specified for the corresponding individual
components relate to chapter drawings.
With the bolts (item 31), the oscillating clamp blocks the oscillation
of the compensation pieces (item 5) installed in the piston. The
bolts (item 31) are moved by screwing in or unscrewing the screw
(item 33).
Switching off the oscillating clamp:
Piston position or jaw position freely selectable.
•
Remove the screw (item 35).
•
Fully screw in the screw (item 33) as far as it will go into the
piston (item 3).
•
Screw in the screw (item 35).
Switching on the oscillating clamp:
The chuck needs to be moved into the open position for shaft
clamping. This could otherwise lead to malfunctions and damage
in the chuck.
•
Remove the screw (item 35).
•
Fully unscrew the screws (item 33) until the stop on the stop
pins (item 40).
Observe the maximum permissible torque. The stop pin (item
40) may be damaged.
•
Screw in the screw (item 35).
5.5