Assembly
30
02.00 | PLG | Assembly and Operating Manual | en | 1517334
6.2.3.1 Connecting/changing the sensor (for IOL variant)
Dismantle and connect the sensor
■
There is no compressed air or energy supply.
■
No workpiece is gripped.
1. Loosen sleeve (2) (SW24) and unscrew.
2. Loosen the set-screw (3) and pull the sensor (1) out of the
sleeve (2).
3. Connect IO-Link cable to sensor (3).
Installing the sensor
1. Push the sensor including cable into the sleeve (2) as far as the
stop.
2. Clamp the set-screw (3).
✓
Tightening torque: 0.2 Nm
3. Screw sleeve (3) into the gripper and tighten.
