Assembly
32
01.00|1343374_MES3 / MEQ3 / MEW3 |en
Information to clamping pin SPG 40
The SPG 40 can be used as a replacement for the SPA 40 with one
clamping area (clamping pallet or workpiece).
For module height extensions with two clamping areas, clamping
pin type SPA 40 can be replaced by the SPG 40 both on the module
extension itself and on the clamping pallet to be coupled. The
clamping bolt type SPB 40 installed should not be replaced.
The repeat accuracy increases to <0.002 mm when using the SPG
40.
When connecting the screws from above, according to order
preference 2, an M12 screw 10 mm longer of strength class 12.9
must be used.
Screw tightening torques
Tightening torques for mounting clamping pins to the module
extension, workpiece or to the clamping pallet.
(Screw quality 12.9)
Screw size
M8
M10
M12
Tightening torques
(Nm)
32
62
108
4.3.1
4.4
Summary of Contents for MEQ3 200-2
