Maintenance and repair work
05.00 | LDT | Montage- und Betriebsanleitung | en | GAS360927
133
Ø
Slightly lift up one side of the covering tape (6) and use forceps
to remove the protective film (5) from the adhesive film.
Ø
Press the covering tape (6) onto the magnetic strip (3) while
pulling off the protective film.
Ø
Unscrew the 2 magnetic strip clamps (2).
7.10 Changing the wipers
Changing the wipers
1
guided slide
2
mounting screw 3
wiper
NOTICE
•
When using wipers, it is especially important that you clean
the guide strips and lubricate them with an oil-soaked cloth.
•
Note that the usable stroke is reduced when installing wipers.
1. Slide the guided slide (1) to the center of the axis.
2. Release the mounting screw (2).
3. Change the wiper (3).
4. Tighten the mounting screw (2).
