Maintenance
64
02.01|FDB 150, 300, 340, 660, 900, 1040 |en
10 Insert the new ring cylinder assembly into the rear housing.
Align the ring cylinder assembly using the mounting screws
prior to pressing the ring cylinder in the bore.
11 Apply Loctite 222 to the M4 socket head cap screws (3x).
12 Place the M4 screws in the through holes in the ring cylinder
body and tighten them slowly and equally using a 2 mm Allen
wrench, so they pull the ring cylinder assembly into of the rear
housing.
NOTICE! Be sure O-ring stay properly seated into
grooves. Tighten to 2.82 Nm.
13 Assemble the rear housing to the front housing.
14 Apply Loctite 222 to the M4 socket head cap screws (6x). Se-
cure the rear housing using the 6 M4 socket head cap screws
using a 2 mm Allen wrench. Tighten to 2.82 Nm.
15 Install the FDB to the robot or work location.
16 Connect the air hose to the spindle supply fitting and the
compliance air fitting.
17 Apply and/or unlock the spindle motor air supply.
Spindle Boot Replacement FDB 660
The spindle boot prevent debris from entering the housing and
protects internal components.
Replace the spindle boot if damaged.
8.3.5
