![SCHUNK EGL Assembly And Operating Manual Download Page 54](http://html1.mh-extra.com/html/schunk/egl/egl_assembly-and-operating-manual_1215894054.webp)
Assembly and settings
54
04.00 - FW 2.x | EGL | Assembly and Operating Manual | en | 389661
Ø
Disconnect the product from the power supply.
✓
LED 1 and LED 2 go out.
✓
LED 3 goes out.
Ø
Switch on the power supply of the product.
✓
LED 1 and LED 2 light up green.
✓
LED 3 lights up yellow.
Ø
Click the "Close" button.
✓
The "Update firmware:" window closes.
5.10.2 Update via USB Micro AB (host)
Service window, PROFIBUS and CAN bus variant
1
LED
2
USB Micro AB, host
3
DIP switch
CAN bus communication interface
CAUTION
Risk of damaging the logic board!
If the product is disconnected from the power supply while the
logic board is being updated, the software will not be completely
installed and can no longer be started. The logic board update
cannot be repeated.
•
Do not disconnect the product from the power supply.
•
If the product is disconnected from the power supply while
the logic board is being updated, send the product to SCHUNK
with a repair order.