General
03.00 | CLM | Assembly and operating manual | en | 389015
7
1.4 Accessories
A wide range of accessories are available for this product
For information regarding which accessory articles can be used
with the corresponding product variants, see catalog data sheet.
1.4.1 Sensors
In the delivery state the sensors are mounted on the product.
For the exact type designation, technical data and information on
handling sensors, see catalog datasheet and assembly and
operating manual of the sensor, available at schunk.com.
Designation
CLM
08
10
25
50
100 200
Inductive proximity switch
NIA50-KT
X
–
–
–
–
–
Inductive proximity switch IN 30
–
X
–
–
X
X
Inductive proximity switch IN 32
–
–
–
–
X
–
Inductive proximity switch IN 40
–
–
X
X
–
–
1.4.2 Rod lock
The rod lock prevents weights from falling in the event of energy
loss, such as emergency stop situations. The rod lock can also be
retrofitted, but this will reduce the useful stroke.
CAUTION
Damage to the rod lock due to incorrect actuation / overload!
•
The rod lock may only be triggered and unlocked when the
product has been shut down.
•
See the data on static holding force in the catalog. The forces
occurring in a clamped condition must not exceed the holding
force.
•
In the event of a dynamic load or overload (e.g. drop in
pressure during movement), the clamping cartridge must be
checked and replaced if necessary.
WARNING
The rod lock is not a safety component for personal protection
in the sense of the Machine Directive.
Exact specifications and ordering data
☞
catalog.
