SCHUNK AOV-MC, Assembly And Operating Manual

Page: 7 / 48

Basic safety notes
2 Basic safety notes
2.1 Intended use
This product is exclusively intended for the automatic removal and
reinsertion of sanding discs with Velcro fastener and for checking
the correct change procedure for orbital sanders.
• The product may only be used within the scope of its technical
data, Technical data [
}
13].
• When implementing and operating components in safety-
related parts of the control systems, the basic safety principles
in accordance with DIN EN ISO 13849-2 apply. The proven safety
principles in accordance with DIN EN ISO 13849-2 also apply to
categories 1, 2, 3 and 4.
• The product is intended for installation in a machine/system or
for mounting to a robot. The applicable guidelines must be
observed and complied with.
• The product is intended for industrial and industry-oriented use.
• Appropriate use of the product includes compliance with all
instructions in this manual.
2.2 Not intended use
It is not intended use if the product is used, for example, as a
pressing tool, stamping tool, lifting gear, guide for tools, cutting
tool, clamping device or a drilling tool.
• Inappropriate use includes using the product as a hand tool.
• Any utilization that exceeds or differs from the appropriate use
is regarded as misuse.
2.3 Constructional changes
Implementation of structural changes
By conversions, changes, and reworking, e.g. additional threads,
holes, or safety devices can impair the functioning or safety of the
product or damage it.
• Structural changes should only be made with the written
approval of SCHUNK.
2.4 Spare parts
Use of unauthorized spare parts
Using unauthorized spare parts can endanger personnel and
damage the product or cause it to malfunction.
• Use only original spare parts or spares authorized by SCHUNK.
7 01.00 | AOV-MC | Assembly and Operating Manual | en | 1461420