Maintenance
28
02.00 | Jaw turning rings | Assembly and Operating Manual | en | 0189701
7 Maintenance
7.1 Basic information
CAUTION
Injury of the eyes by dirt particles
When cleaning with compressed air, the eyes may be injured by
flying dirt particles.
•
Wear suitable protective equipment, particularly protective
goggles.
For trouble-free, long-lasting use, clean, maintain and check the
functionality of the product regularly.
Repair work may only be carried out by SCHUNK!
If you have any questions regarding maintenance and servicing,
our technical
customer service is available during our business hours:
Service telephone: +49-7133-103-2956
[email protected]
7.2 Intervals and tasks
Operation
Interval period
Cleaning and testing the product
after every clamping procedure
The specified maintenance intervals are based on practical
experience gathered by SCHUNK and are recommended.
Depending on the ambient and operating conditions, as well as the
clamping frequency of the product, the maintenance intervals
must be adapted and noted accordingly. For maintenance intervals
with two or more specifications, the valid specification is the one
that applies first.
7.2.1 Cleaning and testing the product
1. Disassemble clamping pin
.
2. Clean the entire product and attachments with compressed
air.
3. Wipe all surfaces dry with a clean cloth.
4. Check the product and attachments, in particular the contact
surfaces, for deformation, damage or wear. Replace if
necessary.
NOTE:
Damage or wear can compromise the functioning of the
product. If non-replaceable parts of the product are worn or
damaged, return the product to SCHUNK for inspection.
